[Mark S.]

Originally Posted by fhkpaintballer

i just got a clone v2 from a good guy off pbn, and i am having a weird issue and im wondering if it is a known one or it just needs some lube.

when i air up the clone there are no leaks, after i shoot 1 ball i get a leak outta the bottom of the reg were you adjust it, i went through half a hopper and it slowly went from a decent leak too nothing, and i finished off the hopper and no other issues, so i de-aired and then put more air through it and once i put on air it was the same thing, no leaks like a champ, but i shot 1 ball it started leaking again(not as bad as before but still a leak) i shoot 20-30 balls and it goes away this time and i finish off the hopper and it still dont leak. i was at the cfps event when i did this and it was a little drizzly that day but im wondering if i just need too lube it, or what may be causing a leak but then fixing its self?

Check the 6x1 o-ring under the reg seat. I'm guessing you're running an HP tank. I would swap out that o-ring and lube it up a little when you replace it.

[fhkpaintballer]

Originally Posted by Mark S.

Check the 6x1 o-ring under the reg seat. I'm guessing you're running an HP tank. I would swap out that o-ring and lube it up a little when you replace it.

yea at the time i was using a high pressure tank, but i have a low pressure tank too, but would it make that much of a difference on what tank i used too weather or not the reg would leak like that?

[Mark S.]

Originally Posted by fhkpaintballer

yea at the time i was using a high pressure tank, but i have a low pressure tank too, but would it make that much of a difference on what tank i used too weather or not the reg would leak like that?

If that o-ring is degraded the HP can push a little air past it. LP typically doesn't have that issue. If you replace the o-ring and put a little lube on it then you shouldn't have the problem with HP either though.

[fhkpaintballer]

ok, thank you a lot for the help. it really helped.

[MikeBuckler]

Hey guys, I just picked up a clone that I have been having some complications with. I have a slight leak from breech area, I have replaced bolt tip and power tube tip o rings and relubed everything else. The leak is very small, but its still there and I'm a perfectionist lol.. Any other ideas?

[SHOOTNPOO]

Swap out the inner Front Keg oring (017) along with the Switch (016) oring on the bolt.
This should help unless you are having leaks from the outter keg orings.

[MikeBuckler]

Alright, I'll have to scoop up an o ring kit so I might be abit but ill be back if that doesn't do the trick

Thanks

[FrodoAKA187]

so dumb question, my clone gt's bolt wont settle when aired up and i replace all the orings and tried over lubing, under lubing and just legit lubing can someone pm me on what i am suppose to do?

[SHOOTNPOO]

What do you mean wont settle???

[supercoolsexyanime]

1. Replace battery.
2. Try to give it some more air and the bolt _will_ "settle". Your hpr might set too low.
3. -

[98Pro]

Sounds like your HPR is way low. In addition to what he said Make sure the middle oring on your bolt makes GOOD contact to the can. The bolt switch oring is what it's called and it's #16.