[cockerfan87]

I didnt have to do anything to the front block, and ive been using the reg on my other cocker for a little bit. I had to replace the orings in it when i got it but other than that its been quite good to me

[cockerfan87]

Originally Posted by Dk-79

Don't forget a big fat expansion chamber.

They help a lot more than they get credit for.

Even with the mq valve?

[PaulE2Cocker]

Yes it could help greatly since your body is a mini.

Here's what I did with my frame took off the full block and made this. This is my first gun I ever owned in 2002.

[cockerfan87]

i love the on/off asa, i use the same on my eblade and will be using in on this project. how is you reg? i was looking at getting that for the half block.

[PaulE2Cocker]

I actually love it do to it saying eclipse kind of adds a finishing touch all matching.Plus look how short macro line is from reg to Asa. It's also +-4 on my autococker. I would recommend it or the aka 2 liter small round very consistent

[PurpleDirt]

Violent SL3 HPRs are phenomenally consistent.

Only problem is they're quite overpriced.

A suggestion on the side would be a Bob Long 360 Torpedo. Relatively as, if not more, consistent than the SL3 and much cheaper and lighter weight. Also simpler for maintenance.



Nice cocker chopping already, although I despise chopped cockers in general unless the bodies are essentially blanks...


Sidenote: You can use any flat-topped frame in which the screws will line up with that of the cocker's. If the screw holes are off, you can always tap new ones in the body anyways. Just be precise about it

[cockerfan87]

Any words on the black magic reg? Pros and cons?

[Dk-79]

Great reg, nightmare to rebuild.

I'm on the fence with those, sometimes the $40 for a new reg is less of a heartache than actually taking a black magic reg apart.

Other than that though, they're pretty good.

[barrel roll]

No worse than a dye reg.

[cockerfan87]

OK I had a little more time (and a few extra dollars), I ended up getting the todao board last week, and the only problem I have so far is that the noir does not click everytime I pull the trigger. I've played with the trigger a little and it got better, but did not completely fix the problem.
All I have left to do to finish the gun is to put all the hoses on and fine tune it ( I'm guilty of getting a little too anxious so I am going to use the reg shown for the time being.) So it should be ready in time to play in a couple of weeks.

[facelesskillah]

wow very nice. i just sent my karni in to get midblocked and the feed neck worked on. but now that i been seeing all these pictures on trigger frames im wanting to get it done as well. what would be the easiest trigger frame to drop in. i hear of the 05 ego a lot???