Automag high pressure reg

Juninhol87 · 10-02-2012, 02:44 PM

I have ax valve, level 10 auto mag, I would like to make it ramp fire, so I'm looking for a high pressure regulator for my 4500 tank like dynaflow , but I can't find it online for sale. Can anyone point me on the right direction ?

Rob @ Ninja PB · 10-02-2012, 02:59 PM

If you have or get RT for your mag, check this reg out:

The NINJA SHP was designed specifically for Automags running RT and Tippmann's running RT and Cyclone Feeds. The reg ships at 1100psi and can be adjusted down to 950psi.

Juninhol87 · 10-02-2012, 03:26 PM

I have this reg shp reg already but I'm looking for something that can go higher then 1100 and is more consistent, I did not like the ninja reg

Juninhol87 · 10-02-2012, 03:46 PM

The again I don't know if its not ramping because my gun is new, my older automag shoots awesome and they are the same guns

Juninhol87 · 10-02-2012, 03:55 PM

I'm not being able to sweet spot it

YeloSno · 10-02-2012, 10:02 PM

That's probably a factor.

Take some time (probably with a video from an experienced tech or airsmith) tuning and sweetspotting it.

I can attest to the lack of consistency from Ninja Regs, but I've never seen an SHP'd mag not be able to RT.

Dark Side · 10-04-2012, 03:55 AM

Quote:

Originally Posted by Juninhol87

The again I don't know if its not ramping because my gun is new, my older automag shoots awesome and they are the same guns

Unless you have an E/XMag with Xmod or the (normally) unreleased (4.01 IIRC) software you don't have ramping.

Sounds like you aren't sweetspotting the trigger and haven't quite tuned the Lvl 10 yet. Mine was a bear to get just right.