[skinz-n-bonez]

Can I use a stock trigger pin with the CP triggers or will I need to get a hold the actual pin that would come with one?

[jim4130]

Because the inner diameter of the bearing cp uses is smaller you have to use the cp screw.

[skinz-n-bonez]

Would anyone happen to know the size and length of the screw they use then? Can just one that I can get from your local hardware store or will I need to contact CP directly?

[jim4130]

Well Im not sure which cp trigger it is but I know with my sft cp blade trigger it uses a screw and 2 bearing races on of which the screw threads into to take the slop out of the trigger and without these races installed that trigger is super slopy. So I would call cp.

[memoon]

Calling CP is your best bet for the reasons mentioned above.

I had one missing those races and the trigger was borderline unusable.

[AO Nick O Time]

Yes, I would recommend calling CP. Even with the 1 extra shim and 1 locking shim they sent me I still had to go to the hardware store and get some more washers though. It was rather sloppy at first.

[DyeBalla182]

Violents FTW, feel much better than CP's imo

[Archhh]

Yes you can use the stock pin.