[818 PREDATORS]

It leaks down the barrel,number 1! Number 2 I have 1.0 bolt and when I put that in there it leaks behind trigger or out grip,number 3 when I put the stock 1.0 bolt guide into the pooty bolt it shoots but then after a few shots the bolt sticks forward and stays forward untill i release air pressure and pull bolt out the back and also it takes a while for the bolt to pull back after fired ! Just got this luxe and its like a turn off I'm a way cause it had a lil leak in.the reg when I got it and then ans gear opened it up check it only to find out the out side reg was stripped ,set screws were stripped and inside if reg was starting to rust almost on.the reg from using oil instead of lube and I got a new reg coming.but man this sucks!

[ncampos976]

put the bolt back in that leaks behind the trigger, then lower your pressure on the reg and see if the leak goes away.

[ErrorCode6263]

The one that leaks down the barrel replace the first inner and outer can oring (closest to the front)

[shockerboy001]

leak down the barrel replace the front can oring and the bolt sail oring the super tight one on the bolt.

[818 PREDATORS]

Hey guys I got a new silenoid now the gun works and shoots cause ans said the silenoid was bad and I got a new 2.0 bolt but now theres a small leak coming from the quick release cap area on the back of the gun the only thing I could think that I didn't replace is the whole back cap that the bolt guide screws into somebody help!!

[Giruc]

theres tiny lil latch orings on the back latch itself check those

[818 PREDATORS]

Where are those located?

[cozmo5050]

Originally Posted by 818 PREDATORS

It leaks down the barrel,number 1! Number 2 I have 1.0 bolt and when I put that in there it leaks behind trigger or out grip,number 3 when I put the stock 1.0 bolt guide into the pooty bolt it shoots but then after a few shots the bolt sticks forward and stays forward untill i release air pressure and pull bolt out the back and also it takes a while for the bolt to pull back after fired ! Just got this luxe and its like a turn off I'm a way cause it had a lil leak in.the reg when I got it and then ans gear opened it up check it only to find out the out side reg was stripped ,set screws were stripped and inside if reg was starting to rust almost on.the reg from using oil instead of lube and I got a new reg coming.but man this sucks!

1) which model luxe do u have, and im assuming used? Your thread title is confusing. 1.0/1.5/2.0 luxe? 1.0 bolt? 2.0 powercore? fully pooty powercore? pooty modded stock core? (if you can, post a pic)
2) was it shooting ok in the past and just recently had issues or did u receive it messed up?
3) what are the current board settings?
4) what is your feather touch/ manifold set to?
5) what tank input pressure are using?
6) have u read the stickes?
here u go: Solving Basic Leaks
7) have u seen Pooty's o-ring fitment youtube videos?
8) have u read the luxe manual? There's also quick trouble-shooting guide in there.

(o-ring fitment is the same and applies to ALL luxe powercores)