NT11 not cycling..

cybermaniac15 · 09-09-2012, 09:22 PM

I have tried charging the battery, the dwell is set to 9, reg is 125-130, it's Bwing'd, changed all of the spool orings, the 2 smaller orings on the plunger, and the ones on the cylinder because it was leaking the other day. Tested it yesterday and it was shooting around 320, brought down to 290, and the gun shot a stream perfectly fine. Brought the gun out today, fully cycled one shot, and then the bolt stopped cycling, and it started puffing.. Haven't touched anything yet, but I just did all that yesterday.

Paint_hore · 09-10-2012, 01:39 AM

Its the noid.

cybermaniac15 · 09-10-2012, 01:58 AM

The noid clicks, and I just tried bumping the dwell to 10 to see what would happen, and it started cycling. Hopefully it keep working but I'll update the thread..

HotxRod · 09-10-2012, 10:20 AM

Solenoid pilot is probably on its way out, but try it with another tank too to be sure.

cybermaniac15 · 09-10-2012, 11:17 AM

The only thing I can think of is that I went from using a ninja SMP 550 reg to using a regular ninja reg. it's been working on my other guns, but it may of changed something?

Special Ed BMX · 09-11-2012, 09:37 AM

Is the bolt not completely reseting?

I had this happen on my NT11 where the bolt would not completely reset. I was running a really low pressure of around 105-110. I ran the dwell higher at 11ms (virtue oled) to get it to cycle consistently.

cybermaniac15 · 09-11-2012, 10:00 PM

It's working great now, up'd the dwell to 10 (virtue oled), and it working great, no issues.. Thanks everyone.