Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 09-04-2012, 12:00 AM #1
baggedbirds
 
 
baggedbirds's Avatar
 
Join Date: Dec 2011
Location: Fresno,CA
1 more Virtue question 05 speed

I understand the trigger now, why does the, what I am assuming is the eye receptical, look like it takes a plug and not the flat thing I have ?

baggedbirds is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 09-04-2012, 01:02 AM #2
dr.strangelove
The Angel Eye Doctor
 
dr.strangelove's Avatar
 
Join Date: May 2003
Location: Earth
 has been a member for 10 years
The eye socket is actually missing in that pic - it goes in the little white-outlined box with the 4 solder joints right next to the large 5 pin molex connector, which is the programming port. The other 2 pin white sockets to the right and just above the programming port are for the solenoid and 05 Speed toggle switch, respectively. Going down from there you have the LED, the dip switch panel (which is for tourney lock), and the 2 buttons (you can see them just below the "V" logo). If you were using the board in a gun other than the 05 or 06 Speed, the top button is used to power the gun on and off. On your speed you will continue to use the toggle switch, which as I mentioned before will be plugged into the white 2 pin socket next to the solenoid port (they are labeled so you won't confuse them).

Last edited by dr.strangelove : 09-04-2012 at 01:10 AM.
dr.strangelove is online now   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump