[blade_x23]

ACP Delrin Vs Teflon bolt, which is better? Why get one or the other? What are benefits of both? Was lookin at gettin a ACP bolt but not sure which one to get. Also is it worth it to get the low blow bolt or does it cause alot of inconsistencies?

Side Question:

Is there any aftermarket ball detents for the Wrath? Like Kila detents or something?

[mexi ca40k]

I personally don't think its worth upgrading the bolt, i have heard that it doesn't do very much.

[tacxplosion]

Lighter bolt (delrin) will make it kick less but might make it less consistent or need to raise LPR pressure, heavier (teflon) will make it kick more than delrin but still less than stock, & it might remain as consistent as the stock bolt.

The only reason I'd change the bolt is to get o'rings on it, if it doesn't have them yet, then again I go for efficiency & consistency over smoothness.

I'd go teflon and get the lightened return spring they also sell. Either one open face with 2 o'rings.

Low blow will do nothing but impair air flow, get open face. As far as detents, I'm not sure that they're exactly the same but you could try timmy detents and clip them if they're too long