Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 07-18-2012, 11:27 PM #1
ETH13
 
 
ETH13's Avatar
 
Join Date: Feb 2012
Location: South Jersey
ETH13 has achieved Level 2 in PbNation Pursuit
Angry Firing assembly problem on ion

Okay. Keep in mind that i have an techt l7bolt in it. So I was taking my gun apart when I stripped where te banjo fitting goes into. he hole is stripped. It is the whole on the swivel donut. So then I took the c clip off of it to replace the swivel donut since it is stripped. I then unscrewed the screw on the back of the firing chamber and the other part of the screw. (on te inside) fell into the firing chamber. When I was trying to get the screw re-screwed, an o ring fell out of the firing chamber but the screw is still stuck in there . What should I do? The firing chamber has a rubber washer in the way so I can not get the screw out that way.
ETH13 is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 07-18-2012, 11:41 PM #2
sumsemperfi
the fat guy
 
sumsemperfi's Avatar
 
Join Date: Dec 2006
Location: Shawnee, OK
sumsemperfi has achieved Level 1 in PbNation Pursuit
sumsemperfi has perfected Level 1 in PbNation Pursuit
By rubber washer do you mean the bolt stop? If so just pull it out. Should just pop right out
__________________
THERE IS A FAT KID ON EVERY PAINTBALL TEAM. IF YOU ARE THAT FAT KID, PUT THIS IN YOUR SIG
sumsemperfi is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump