ok, so this question is a bit more involved than the usual and i need a bit of help with it from you guys.
based off of these,
im attempting to figure out the configuration of the 4 leads for the eye sensor. im assuming the 1 and 2 labeled in the first schematic lead to the LED which would correspond to the top left and bottom left lead on the eye, while 3 and 4 (top and bottom right) lead to the sensor. Does it matter which is attached to the ground or power? im also assuming that while looking at the upper board schematic, 1 and 2 are the left most ports on the board, correct?
i plan on using a T-board for a project and want to use the stock eye sensor instead of dremeling the **** out the body to accept BB eyes
if anyone can tell me the order of each of these I would really appreciate it.
each of these four leads correspond to the LED ground, LED power, Sensor power, and Sensor ground according to Scenario Dreams. Im assuming this is the case for the shocker eye as well.
if someone could post or PM me that would be awesome.