[CarsonRemchuk]

Hey guys the power button is sticking on my gun and dont know what to do, what should I do?

[eskeoto]

Is it the power button in the board or the rubber part? Doesn't really matter. Either way, take it apart and make sure there isn't any debri or something making it stick.

[CarsonRemchuk]

Its the one on the outside, do I need to take off the plate around the screen?

[CarsonRemchuk]

I cleaned some of it out and FOR NOW it works fine

EDIT, its still kinda sticking a little though

[msonic]

Wash your fingers so they don't stick to it?

[allout2]

Originally Posted by msonic

Wash your fingers so they don't stick to it?

Hehehehe, smell my fingers

And as eskeoto stated just make sure nothing is getting in and causing it to stick.

[lopez17]

I recommend removing all the honey from the exterior of your gripframe.

If you have a little bit of rubbing alcohol, use some of it on a q-tip to go through the interior of your gripframe to remove any sticky elements and "clean it up" a little bit.

[cfl mike]

I just had this problem.

What you need to do is open up your grips, and take out the 2 screws on the back of the grip frame on the inside that hold the button in place (I think the screen is connected to it too). Then what I had to do is take some good gripping pliers and GENTLY pull the button out, and while gripping it, turning the button (like spin the button a couple times around while gripping it with the pliers, the button on the board) to keep it from getting stuck again.

[D-man[WarLlamas]]

Carson, bring it to PBA Sat, and I'll fix it for you.