Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 06-14-2012, 09:51 PM #1
Intern1's Avatar
Join Date: May 2012
Location: Gallifrey
Annual Supporting Member
Intern1 is Legendary
Intern1 supports Ninja Paintball
Intern1 supports Empire
E-99 Avant leak

So I decided to pull out my E-99 avant that has been sitting in my closet for about 4-5 years and when I screw in my c02 tank the air just flow out of the barrel. I have a complete o-ring kit on the way so I can replace all of them but which one(s) should I look at first that migh be causing this problem?
Intern1 is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 06-15-2012, 01:21 AM #2
theblindchicken's Avatar
Join Date: Jun 2011
Location: Long Beach, CA
theblindchicken is an NCPA player
theblindchicken is an NCPA National Champion
theblindchicken plays in the APPA D5 division
You might not even need to replace the orings. Try cocking the bolt first, then screw in your tank. Most of the time, the striker sits against the valve pin and therefore allows air to flow freely down the barrel.

If that's not the issue, then check the front bolt oring or the one on the valve closest to the vertical adapter.
theblindchicken is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump