I just aquired a nt10 and can't get it to shoot. I have gone through the manual and attempted the suggestions offered such as replacing the battery, cleaning the eyes, etc... The eyes appear to be working fine and when a ball is in the breach the light turns green, but when I pull the trigger it starts flashing green and won't fire. The board is active and "clicks" appropriately for the setting (ie. Psp, automatic, millennium.) so I am assuming there is nothing wrong with the board. Any help in resolving this will be greatly appreciated.
I raised the dwell to 8 and still nothing. Now i get no puff of air but still clicks. It is like when the eyes are off and you get the same effect. There is air going to the hyper reg because it has a little leak that i can hear, and once again the eyes appear to functioning appropriately. Doesanyone know if Ican send something like this to Dye and have them check it out. I see a lot of posts that there are upgraded parts for this marker, but I don't think this gun has the upgrades.
I was referring to the same thing above. Particles from the air supply go into the tank and travel all the way to the solenoid assembly and clog the tiny air canals on it. Sİnce the ports are too tiny, it's not always possible to clean it. You could give it a try though.
relube the entire gun with extra attention to the spool
set your dwell to 9 or 10
zero out the reg, aka screw it all the way in, back it out and see if you can get it to cycle.
also check your bumper 111 or 110 oring whatever it is, or the orange bumper on the 11, the 016/15 on the bolt can also cause this sometimes too.
hore also has a good idea in looking at your solenoid. I would unscrew the manifold, take the orings off and blow some air through the canals to clean them out.
For those that have similar problems to this, MorpheusX's advice seemed to work the best for me. I resolved the problem by zeroing out the reg by screwing it in all the way until it started to get snug. At this point I turned it out 3 1/2 turns and it started working again. Thanks again for all the input.