[-Smurf-]

Does any one know if there is a shorter bolt pin for the 2011 Indy. when i had my rotor, the fin just barley missed the pin, now that i have a Z2, it sits lower and if i set it all the way down the bolt pin will hit the rip drive.

[smokeage]

Originally Posted by -Smurf-

Does any one know if there is a shorter bolt pin for the 2011 Indy. when i had my rotor, the fin just barley missed the pin, now that i have a Z2, it sits lower and if i set it all the way down the bolt pin will hit the rip drive.

Oh god, im about to buy a Z2

Jack, we need a low-profile bolt pin like Techt made for the G6R!!!!!!!

[Captainhammertime]

I have a Z2 in my Indy and it doesn't hit the bolt pin, however I I've slightly less than a millimeter of clearance haha

[l1ryan1l]

ego 5-6 bolt pin may just work, but i would consult jack about that first because there might be some side effects of using an incorrect bolt pin. If things don't line up perfectly you can end up with the ram mushroomed where the bolt pin slot it, or bend the bolt pin, or crack the bolt or etc etc...

[-Smurf-]

I'm sure jack will make a smaller pin soon. when i had my rotor it just bearly missed. there was only about 3/8'' clearence. but with the Z2 i have to lift the hopper up so it clears the rip drive.