Originally Posted by Enter The Nutty
if the wire came out of the harness then you can fix it. It's a pain in the ***, but I did it with my eye harness. I used an earring to push out the connector inside the harness. To do so you need to push the earring up through the hole that it connects to the board with, you will need to kind of angle it so the connector pops out.
Once out, you need to spread the connector open. I used a knife to do this. Then you need to feed the wire into the connector. I had to cut a little rubber off the wire to expose more metal and left it so there was rubber in where you need to crimp the connection back together.
Now use a pair of needle nose pliers to crimp the wire in place. Then take pliers and put one side on the connector and the other on the other side of the harness. When you squeeze the pliers together it will push the connector back in, and Bam! Good as new.
I apologize for any vague names I may have used to describe things...I worked last night and have now been up over 24 hours. If this is what you need to do and have any sort of questions, PM me. This isn't the easiest way to go about things but any money saved is awesome in my book. It will be a pain in the *** the first time you do it, but this works on MOST electronic harnesses out there.
This was excatly what I was thinking of doing, wanted to double check before I did anything tho. I will get some pics posted in a few minutes.