[TOS Bravo]

I recently acquired an HK Legend that needed some work done to it. As of now I am attempting to take off the front block, but the screw that locks the block in place is somewhat underneath the air hose fitting, and thus won't come off... This a common problem with HK Legends? Any ideas?

Edit: Also, with the soft tip bolt I ordered it came with a "bumper" oring for the rammer. Is this necessary, and if so, is it supposed to be placed on the recessed/groove area on the front half of the rammer (hard to describe w/o pictures)?

[killer_ghost]

Try moving the hose a bit it before unscrewing the screw under it.

Yes you need to use the new bumper you recieved. You replace the fat bumper on the rammer with the smaller one you got.

[TOS Bravo]

Thread revive; does anyone know if it is possible to get a replacement LED plastic covering that goes on the outside of the frame? Mine crumbled.

[TOS Bravo]

Woops

[Worldeater]

Replacement LED cover should not be a problem. Have you shot an email to info@infinitylegend.com / infinitypb@earthlink.net ? Im sure Glenn can hook you up