[Istobla]

Now that i have the attention of everyone who has ever owned a Zeus pistol or clone, i will explain.
A spyder barrel will not fit a zeus, but it is the same thread, 1.5mm, and the same diameter. the non threaded part is the only thing stopping it. If it were trimmed, it would fit, in theory. A couple of the paitball stores i frequent have barrel bargain bins, so i will pic up a spyder threaded barrel and cut it to fit and update this thread. Just wanted to put this out there because i have looked, i have found a lot of people asking where to get zeus barrels and noone offering up answers.

So, anyone know the best way to cut a barrel clean, without a lathe?

[killeralibi66jr]

i would get a copper pipe cutter from menards and then sand the edge with 400 grit paper. go very slow with the pipe cutter and dont tighten it to much or you will dent the barrel

[killeralibi66jr]

i did it i used a pipe cutter and it worked i have a 3" spyder barrel on my warsensor zeus g2