[Blue_Cobra]

Originally Posted by cmdrsuds

That's a plug screw. If the leak is coming from there then remove it, put locktite on it, and tighten it down. Give it plenty of time to set.

I think Teflon tape would be best cuz then you could remove it if you needed.

[kwik]

yah if you can get teflon tape on that small screw use that, otherwise use less than 1 drop of Blue loctite. A lot of times I have to wipe most of it off of small screws as even 1 drop is too much.

[Blue_Cobra]

Originally Posted by kwik

yah if you can get teflon tape on that small screw use that, otherwise use less than 1 drop of Blue loctite. A lot of times I have to wipe most of it off of small screws as even 1 drop is too much.

So true. If you can get teflon tape to look good then use that. I don't really know the difference between red locktight and blue locktight though. I haven't used those very much. Just red for the most part.

[2Pi]

Replace the cup-seal (if yours has one)

[kwik]

Red loctite is supposed to be more permanent, something you dont plan on removing for a long time if not ever.

Blue gives you very similar locking but is meant to be able to break away easier than red, so I use blue on everything paintball related and red I have only used on cars and other items.

edit: just relized the OP hasnt posted in this thread for over a month, hopefully he got it sorted.

[mo11]

Thanks everyone i think i got it, but ill leave this thread alive for others with problems!