Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 03-11-2012, 08:36 PM #1
HateQuitters's Avatar
Join Date: Apr 2002
Location: San Francisco, CA
 has been a member for 10 years
HateQuitters has achieved Level 1 in PbNation Pursuit
HateQuitters has perfected Level 1 in PbNation Pursuit
Marq 7 and Dye Rotor?

Long time member just getting back into the sport again. I did a search and didn't have any luck. I'd be shocked if no one has come across this yet.

I have a Marq 7 and just picked up a Dye Rotor. The Rotor is too thick to fit into the Marq's stock feedneck. Do I sand the Rotor? I've seen aftermarket feednecks, but I think it would raise the height of the loader by a little less than an inch. Anyone come across this yet?
HateQuitters is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 03-11-2012, 08:48 PM #2
Read the manual!!
gamer565's Avatar
Join Date: Dec 2005
Location: OK
Annual Supporting Member
 has been a member for 10 years
gamer565 is playing at Living Legends VI
gamer565 is playing at Living Legends VII
gamer565 is reppin' sidebar 4 life
gamer565 has achieved Level 6 in PbNation Pursuit
gamer565 is one of the top 100 posters on PbNation
gamer565 is Boss
Just sand the rotor.
Jolly Green (╯□)╯︵ ┻━┻

gamer565 is offline   Reply With Quote
Old 03-30-2012, 11:14 PM #3
vnandez's Avatar
Join Date: Jan 2009
Location: New York
vnandez has achieved Level 2 in PbNation Pursuit
I had a Marq7 and had the same problem, called BLAST and got the clamping feedneck. Well worth the money. If you don't have the extra cash to blow sand it down.
Really miss my Marq7 that's a great gun
'To look behind or to look upfront is not as important as to look inside.' - Randolf Waldo Emerson
vnandez is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump