Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 01-05-2012, 09:12 AM #1
Fangedterror
Pump Zone
 
Fangedterror's Avatar
 
Join Date: Apr 2010
Location: Charlotte, NC
ANS 2k Quick Pull Bolt

Hello,

I was looking at my ANS 2k Quick Pull Bolt on my ANS gx-4 Cocker yesterday. and I realized the O rings on the bolt don't have a larger diameter then the bolt its self. In fact the o rings are flush with the edge of the bolt so when you run your hand down the side of the bolt you Cant feel that the orings are there.

So my question is, Is this a problem? Or is this normal for an Autocockers?

Thanks!
Fangedterror is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 01-05-2012, 02:08 PM #2
addicted2dunes
 
 
addicted2dunes's Avatar
 
Join Date: Dec 2011
Location: Orcutt, CA
addicted2dunes has achieved Level 1 in PbNation Pursuit
As long as the pin doesn't just fall out I'd say you're good.
addicted2dunes is offline   Reply With Quote
Old 01-07-2012, 04:24 PM #3
ficone
 
 
ficone's Avatar
 
Join Date: Mar 2006
Location: Brooklyn/Oneonta NY
ficone owns a Planet Eclipse Ego
ficone has achieved Level 1 in PbNation Pursuit
ficone has perfected Level 1 in PbNation Pursuit
All my autococker bolts with orings are just like yours. If bolt orings were much bigger they would cause too much drag. They are slightly bigger you just cant see it with the naked eye. They are there to help with blowback. So yes its normal.

Last edited by ficone : 01-07-2012 at 04:58 PM.
ficone is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump