[sphynx]

Recently came into a E2 cocker. Looking to find out what body it is. I will be home to post a picture later, if needed. I was hoping someone could point me in the right direction if you have a cocker body thread ( I didn't see one). If you do, I can look through that first. Thanks for reading.

[Fearless_Leader]

last count was 300+ body milling, we will need a picture

[sphynx]

[Fearless_Leader]

aim prototype

[sphynx]

Thanks. This body worth saving? I like the milling. Pretty clean.

[Rebel_816]

aim bodies werent rare or special or anything, but yea almost all of them have pretty cool milling. thats a pretty nice looking gun.

[sphynx]

Thank you

The back of the body has been worn down weird from the bolt. See the shiny part of the bolt in the first pic? That's rubbing on the body. Also found out the noid leaks I re-greased the piston and checked orings and seals. Darn thing still leaks. I want to get this gun up and running!!!

[Rebel_816]

if that bolt is metal id get a delrin bolt & pin for sure.

did you check the gasket between the cocking noid and housing? its pretty common for them to go bad if theyve sat forever without any lube. usually they still look fine but will leak no matter what you do.

you can get one a www.paintballgateway.com

[sphynx]

The bolt is derlin, but the part that's aluminum rubs on the back. New bolts a good idea.

I checked all the gaskets ( checked the one where the hoses go like 20 times) It appears fine, but that's where the leaks coming from. Tried greasing it up, with no effect on the leak.

I have a new noid coming to me soon, and I will also order a new gasket! Thanks for the link man! I really wanna get this thing working perfectly. Might keep it. The more I look at it, and hold it, the more I wanna keep it...

[blame it on god]

Have you tried turning the lpr down?

[sphynx]

Next time i'm at the field and have air I will. I was thinking if the reg was too high, the noid would leak. Right?

[blame it on god]

The noid will vent at about 100psi.