[N2extreme1]

Hardboy

The fittings on the launcher are macro fittings. You can use any size hose you want. I run my line down the back of the grip and cut bike tires into thick rubber bands to put around the grip and keep the hose tight against it.

[M.I.S.F.I.T.]

The small black hose is a macroline. But trying to run the line through the handle is not that east as there is a boly running the entire length that attached the grip to the launcher. Honestly it is the best set up other that mounting a 13ci ot a 22ci tank parallel to the barrel. Any shorter length of hose will make it a pain to grab easily.

[r_clarke]

Wanted to BUMP this thread up cause it's a must read/bookmark for any HAVOC owner

If you guys haven't already, join the NERF HERDERS LAW GROUP ON FACEBOOK https://www.facebook.com/groups/368486069847354/

[Abnmp78]

I've been having a problem with the o-ring. Won't fire or blows out. I see I have found my problem.
http://www.oringsandmore.com/servlet...h-rings/Detail
Is this the correct size o-ring? When I have it working it's fantastic.

[Mitchel01]

Anyone tried making some sort of sleeve or cartridge for launching grenades or multiple paintballs?

[Abnmp78]

Made one for my breech loader. Use 3 10 round tubes, 1 1/4' PVC connector. And 1 /1/2" PVC connecter (use that to make the ring so it doesn't slide down the tube). Sand out the inner ring on the 1 1/4. Cut the ends off the 10 round tubes. Tape together the tubes and insert in the connector. Fill with silicon etc to make air tight. Cut a ring off the 1 1/2 conector. Sand the outside of the 1 1/4 to fit the ring on. Once in place sant the outside of the ring until will fit. Load 3 PBs per tube. You can use anything to keep them in. I used a spyder ball detent on each tube so I can load it while still in the gun.