[PeanutWing]

My Psychoballistics Superbolt Pump's bolt isn't receiving air properly... The bolt is right side down, with the hole facing the floor. Air is reaching the reg, but I am not sure where it is stopping.

Can anyone help?

[EvilAuthorityX]

the reg is set too high, the valve cant open

[PeanutWing]

As soon as I went to adjust the pressure, air began leaking down the barrel. Yes, the gun was cocked before I screwed the tank in

[EvilAuthorityX]

if the gun is cocked and its leaking then its a valve problem

if its just leaking down the barrels when you shoot, the reg is now too low

[PeanutWing]

Alright, sounds like a valve problem. Pulling the trigger does nothing to fix or cause the leak

It is also leaking out from behind the trigger

At this point I can turn the leak on/off with a turn of the reg

[EvilAuthorityX]

that means your reg is completely turned off and by turning it on the gun is leaking

[The Inflicted]

Originally Posted by PeanutWing

Alright, sounds like a valve problem. Pulling the trigger does nothing to fix or cause the leak

It is also leaking out from behind the trigger

At this point I can turn the leak on/off with a turn of the reg

Sounds like the valve has come unseated.
This happened over and over on my Superbolt until I loc-tited the jam nut.
Have you had your valve out?
Do you own an autococker valve tool?

[Castro #66]

Check the valve oring as well.

[Rockwings]

It could also be a crack in the cup seal. Mine had that problem.

[drgonzo]

Originally Posted by Rockwings

It could also be a crack in the cup seal. Mine had that problem.

That would not explain leaking near the trigger

[Cheers!]

Originally Posted by Rockwings

It could also be a crack in the cup seal. Mine had that problem.

This was my very first thought.