hey guys...just put an mq2 in my karni...its all put together accept the wiring to the board...so the eyes are plugged in obviously but now with the mq2 i have three wires and two slots...what wire gets illiminated...and of the two wich goes on top and wich goes on bottom? thanks in advance!
simple way to test is to put the board into classic mode, if the valve vent as you are holding onto the trigger it's in the cocking noid slot. the venting should stop once you release the trigger. if the noid make a pop sound when you hold onto the trigger it's in the proper sear noid slot.