NT10 Bolt and the Cylinder is Stock.
1. Solenoid Manifold
3. Spacer rod
4. Red bolt tip
5. Green flow insert
6. 015 o-rings ? (Should I Change the bolt oring color brown #016 with the red #015 ??)
A) What is the correct Dwell setting for the NT10 to work propery with this 6 new part install?
B) What is the lower operation PSI can be used to make the marker cycle properly with all this parts install. (Stock is no lower than 130 psi and no over 150)?
c) Normaly Dye NT10 Need a spacer rod install to work-cycle properly at Velocity "fps" 285. With the above 6 parts in I still need spacer rod in?
After the new part insert in my market what user manual I must follow, nt10 setting or nt11...