[skuzi]

I got a board and I think its for the extcy.
there are 2 mode parameters that I can't find out what they are
when programing
solid red- fire mode
solid green- vision
solid yellow- dwell
fast blink red- bps cap
fast blink green- bps fine adjust
fast blink yellow- burst count
slow blink red- FSDO
slow blink green????

does some know?
thx

[Dedloc]

If it is an extcy board (didnt know they fit the envy) just go to the gog website. They have digital manuals.

[skuzi]

Originally Posted by Dedloc

If it is an extcy board (didnt know they fit the envy) just go to the gog website. They have digital manuals.

It's not an extcy board it's blackheart but I got the extcy instruction with my board!!
The manual for the blackheart says that the slow blinking red is for FSDO, now I'm still missing the last programmable setting...slow blinking green??? no one knows.

[Dedloc]

http://www.gogpaintball.com/docs/manuals/extcy.pdf

The extcy board IS a blackheart board.

Per this manual from the GOG website, slow blink red and slow blink green both have to do with Rebounds modes and how many times the trigger must be pulled to enter that mode when set to Rebound.

FSDO is a slow blink of both red and green. Took me about 5 seconds to actually look that up lol.

[skuzi]

Originally Posted by Dedloc

http://www.gogpaintball.com/docs/manuals/extcy.pdf

The extcy board IS a blackheart board.

Per this manual from the GOG website, slow blink red and slow blink green both have to do with Rebounds modes and how many times the trigger must be pulled to enter that mode when set to Rebound.

FSDO is a slow blink of both red and green. Took me about 5 seconds to actually look that up lol.

OK smart guy! but the manual that you are talking about says that the setting for FSDO is blinking red and green (alternating).

The last setting that I'm trying to figure out on my board is slow blinking green and its values are only 1 or 2...so on/off I'm guessing.
On/Off what though??
is it maybe for Air or CO2?
Thanks for trying to help me.

[Dedloc]

If the settings from this manual do not work for your board, then you either have a bad board or its not the extcy board. If it is an old blackheart board, do a google search for blackheart boards and find it there. Other than that, I would say that slow blinking green is what the manual says, which is enter rate for Rebound mode.