[KuKu]

I just got new nt11 parts for my nt10....spool and spacer rod. Installed them and everything sealed fine and shot good but was way to loud. I check my reg pressure and it was at 150. I turn it down and try again, i now can only one ball it. When i go to rip on it, it just starts making puff puff noises. Im not sure what the problem is im thinking either the reg or the tank reg? Also when i pushed the air release button to let air out of reg it was very slow recharging back up to what i had it set at. Also have the red tip with green flow insert.

[jayrod77]

increase the dwell up to 9(its the factory value of the nt11)

[KuKu]

ok yeah i'll try that thanks.

[KuKu]

that fixed that issue but my reg is still spiking a little bit tho from where i set it at 125. it will spike from there to 135 but im not sure if this is a problem with the reg or the reg tester.

[MorpheusX]

Change the 007 or 006 in the hyper3 And or check the shim order in the reg, or even replace them. My 11 had an issue like that all of a sudden. Replaced the shims and it's good to go