I got done with a session on Saturday, and today the eyes in my gun don't work. This is the first problem I have had with my creed. I was out for about 5 hours Saturday and being a guy who takes good care of his stuff I inspect my gun, clean, and take the battery out to store my gun. Took it out today to test fire the creed with a new hopper and the eyes don't work at all. I pull the trigger and an ! appears. Does anyone know what's wrong?
So I tried both of these things and I thought that it had fixed it. When I turned the marker back on it seemed normal, until I pulled the trigger when the eyes detected something in the breach. It did the same thing as before hald circle with a !. Then I pull the trigger again and I get the red circle back and there is a small ! in the top right corner.
You can also try the basics first...cleaning the eyes and the holes in the breach where the eyes are located. Sometimes you get debris in there and it causes a fault. Eye faults are generally simple to correct. I wouldn't worry much. I'd clean first, make sure the eye wires are plugged in completely, then start worrying about the settings etc. Start simple.
VANGUARD CERTIFIED MASTER TECH
Dead Box Sports
West Coast Parts, Service, Warranty, and Distribution www.deadboxsports.com
I am running into the same issue that the OP is, tried everything stated here and whenever i turn the marker on it still says that there is a ball in the breech (or something) and i get the same ! as the OP does.
mine randomlly did this for some reason...i just realined the eyes. It can be tricky getting the eyes/spring/detent in the right place while tightening the eye cover down. make sure as you put the eye cover on that the eye doesnt move out of place.