Loosen your board screws cause the buttons may be too tight and pushing it
I never "over tighten" anything, I sometimes find it funny when people over do it with the NT's barrel and then crack their eye pipe...
I checked the thread that you added, I’ve squeezed the grips to see if that’s the problem, and it’s not that either…
Thanks anyway for the help!
How crazy is this situation...
If Tadao made it so that the OLED could be seen without taking off the grip no one would buy the Virtue Board.
If Virtue would just use a regular 9v battery no one would buy the Tadao board.
So far I haven't had any good experiences with Virtue; I was trying them out with most of their products, to see if it improves anything. I have the Virtue Rotor board, RF kit, soft cycle and OLED. Only thing so far out of that list that worked properly first time installed is the RF kit.
Am I just jinxed or do other people have problems with virtue products?
I’m not smashing on the products I’m just telling what my experience is so far with virtue.
I must admit Virtue has extremely good customer service, If you need help.