Inoviq 2.5 glitch?

isaaclim · 03-30-2011, 10:59 PM

Hey guys, quick question.

My quest came with a stock inoviq 2.3 board and I sent it to inoviq recently to get it flashed to the 2.5 programming. I seem to have a weird board issue though. I am trying to set it to psp 12.5. It seems to keep the settings fine, but when I turn the eyes off to test, it wont ramp. Its clearly set to psp at 12.5 when I check the blinky lights, but with the eyes off its semi auto. Oddly enough, in demonstration mode it shoots at psp 12.5. Is this a glitch or an unwritten safety feature of eyes off? (can't find it any wheres in the manual)

Physcojosh · 03-30-2011, 11:02 PM

im pretty sure its a safety feature, it assumes you Broke Paintball , and switch to Semi mode, so you wont Turn it into a blender

isaaclim · 03-31-2011, 06:56 AM

The lucky board I had did not behave like this. I do not have air and paint to test to see if the inoviq works with the eyes on. But this does seem contrary to how most other boards operate.

dj red dog · 03-31-2011, 07:39 AM

Try asking Inoviq themselves.

isaaclim · 03-31-2011, 10:20 AM

yeah, I sent an email along to Inoviq today. Was wondering if anyone with the new critical quests would be nice enough to test their boards if they had the time

AaronGPB · 03-31-2011, 12:50 PM

I had that same issue, and then realized that that's whay it's supposed to do.
It only ramps with the eyes on!!!

Goodluck man!!

Whitey818 · 03-31-2011, 02:05 PM

with eyes off it goes semi if you read your manual there is a demonstration mode that will show it in the mode idk off the top my head the dipswitch config but if you read your manual it will tell you.

isaaclim · 03-31-2011, 04:13 PM

mucho thanks guys. I was looking at the manual for this info at 11pm so I'm sure my iron concentration was compromised

Again, much appreciated aaron and whitey.