Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 11-17-2010, 03:04 PM #22
wesr
 
 
Join Date: Feb 2009
finally got my hands on a chrono... should reball chrono at the same speed as paint at the same pressure or should i see a lower speed? i think reballs are a little heavier. just so i know what im lookin for in my results
wesr is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 11-17-2010, 07:37 PM #23
Ragin Cajun
CLICK, CLICK, BOOM
 
Ragin Cajun's Avatar
 
Join Date: Dec 2001
Location: South Louisiana
Annual Supporting Member
Ragin Cajun is a founding member
Ragin Cajun is one of the top 1000 posters on PbNation
Ragin Cajun is a Forum Captain
Quote:
Originally Posted by wesr
finally got my hands on a chrono... should reball chrono at the same speed as paint at the same pressure or should i see a lower speed? i think reballs are a little heavier. just so i know what im lookin for in my results
Reballs are much smaller so they would probably chrono slower if you are using the stock barrel.
Ragin Cajun is offline   Reply With Quote
Old 11-17-2010, 08:29 PM #24
wesr
 
 
Join Date: Feb 2009
Results Are In Check It Out
wesr is offline   Reply With Quote
Old 11-17-2010, 08:43 PM #25
drei-eins
chuckoslovakia
 
drei-eins's Avatar
 
Join Date: Feb 2008
Location: ATX
drei-eins is for the Gunfight
drei-eins has achieved Level 3 in PbNation Pursuit
X rings should only be used on stationary parts such as the inner ring on the can and similarly on a matrix's top hat. they should NOT be used on any moving parts for example the bolt sail or bolt tip of bolts.
__________________
NYX Battleship Grey Matrix #99
Deutscha Bad Boy Mini
REGENCY CROME 2
drei-eins is offline   Reply With Quote
Old 11-17-2010, 08:48 PM #26
wesr
 
 
Join Date: Feb 2009
i didnt use them for the bolt sail or the bolt tip, just the inner can ring and the 2 orings on the plunger, the green 012 and the blue 014.
and really when you think about it they all touch a moving part anyways, it doesnt matter if it is moving or the other sealing surface is moving its all the same forces anyway. plus one of the advantages about them is the resist twisting and blow outs better than a standard oring.... i have looked well into this.

Last edited by wesr : 11-17-2010 at 08:51 PM.
wesr is offline   Reply With Quote
Old 12-23-2010, 05:02 AM #27
icehouse1
 
 
icehouse1's Avatar
 
Join Date: Dec 2006
Location: Georgetown, KY
The question is still out there from someone before, where to get these?

I am also interested in your findings. Where are they located?

Thanks..
icehouse1 is offline   Reply With Quote
Old 12-23-2010, 08:03 AM #29
wesr
 
 
Join Date: Feb 2009
look up local seal dealers, my local place i got them from was called fluidseal, use yellowpages and look up seal dealers and it should bring something up local for you. or look for somewhere online
wesr is offline   Reply With Quote
Old 12-24-2010, 02:31 PM #30
rossmorgan29
Check Please
 
rossmorgan29's Avatar
 
Join Date: Jul 2010
Location: Dallas Tx
rossmorgan29 owns a Planet Eclipse Geo
Here's the thing.. No local seal dealers. Tried to google it. Came up with squat. I just wanna find somewhere to order them from
rossmorgan29 is offline   Reply With Quote
Old 12-24-2010, 03:30 PM #31
Ragin Cajun
CLICK, CLICK, BOOM
 
Ragin Cajun's Avatar
 
Join Date: Dec 2001
Location: South Louisiana
Annual Supporting Member
Ragin Cajun is a founding member
Ragin Cajun is one of the top 1000 posters on PbNation
Ragin Cajun is a Forum Captain
McMasterCarr has them.
Ragin Cajun is offline   Reply With Quote
Old 01-02-2011, 04:53 AM #32
icehouse1
 
 
icehouse1's Avatar
 
Join Date: Dec 2006
Location: Georgetown, KY
Here is the number for where I got mine at. (859) 885-4155 This out of KY, but if you can't find them close to you, it is an option.

Don't quote me, but I think it cost me about $9 for 10 of each quad ring, shipped.

Last edited by icehouse1 : 01-02-2011 at 05:03 AM.
icehouse1 is offline   Reply With Quote
Old 01-03-2011, 02:29 PM #33
redz64
 
 
redz64's Avatar
 
Join Date: Oct 2004
Location: 325
I've got some. Pm me.
redz64 is offline   Reply With Quote
Old 01-16-2011, 09:57 AM #34
icehouse1
 
 
icehouse1's Avatar
 
Join Date: Dec 2006
Location: Georgetown, KY
Well, I put air on my NT yesterday and had a leak! I immediately took the quad rings off and everything was fine.

Anyone else had this problem? Any solutions for me?
icehouse1 is offline   Reply With Quote
Old 01-17-2011, 03:23 PM #35
MorpheusX
The Tfare
 
MorpheusX's Avatar
 
Join Date: Nov 2001
Location: Niagara Falls
MorpheusX is a founding member
 has been a member for 10 years
one of your rings is twisted and not seated correctly. try them again, run your nail down the center to make sure the groove is uniform all around and in the middle of the ring.
__________________
Rockland Hustle AXBL Alumni ; Toronto Rage CXBL Alumni ; Rochester Rhythm Alumni ; Niagara Falls Savages USPA

Windsor Lockdown - CXBL
Syracuse Rhythm - PSP

MorpheusX is offline   Reply With Quote
Old 03-26-2011, 10:02 AM #36
nickdude
well do ya punk?
 
nickdude's Avatar
 
Join Date: May 2008
Location: New Jersey
Annual Supporting Member
nickdude donated to help Peyton Trent
nickdude is playing at Living Legends III
nickdude is playing at Living Legends V
nickdude supports DLX Technology
Any follow up to this? Long term results?

Thanks
__________________
Generously Supported by

Valken * Quickshot * Gog/Luxe * Guerrilla Air * TechT * Xtreme Dreamz * Fog Doc* Deadlywind
Media partners Help keep Paintball Alive * CatShack Reports
LUXE MOBClone GT Militia
nickdude is offline   Reply With Quote
Old 03-26-2011, 12:26 PM #37
MorpheusX
The Tfare
 
MorpheusX's Avatar
 
Join Date: Nov 2001
Location: Niagara Falls
MorpheusX is a founding member
 has been a member for 10 years
still using the same set i put on when i originally posted, probably around late oct early november. Not one issue. The gun is currently running at 100psi-105psi, green insert, dwell of 10, at 290 fps.
__________________
Rockland Hustle AXBL Alumni ; Toronto Rage CXBL Alumni ; Rochester Rhythm Alumni ; Niagara Falls Savages USPA

Windsor Lockdown - CXBL
Syracuse Rhythm - PSP

MorpheusX is offline   Reply With Quote
Old 03-26-2011, 12:33 PM #38
wesr
 
 
Join Date: Feb 2009
nt10 or 11?
wesr is offline   Reply With Quote
Old 03-26-2011, 05:23 PM #39
nickdude
well do ya punk?
 
nickdude's Avatar
 
Join Date: May 2008
Location: New Jersey
Annual Supporting Member
nickdude donated to help Peyton Trent
nickdude is playing at Living Legends III
nickdude is playing at Living Legends V
nickdude supports DLX Technology
Also was it the 17, 12 and 14?
wondering if the spool 10's would be worth trying?
Thanks
__________________
Generously Supported by

Valken * Quickshot * Gog/Luxe * Guerrilla Air * TechT * Xtreme Dreamz * Fog Doc* Deadlywind
Media partners Help keep Paintball Alive * CatShack Reports
LUXE MOBClone GT Militia
nickdude is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump