Tools and supplies you will need for the aquired task at hand. (PMR Approved Lubricant, 1/4 Size Hex Allen Key)
Having a PMR will make this process go alot faster
With your 1/4 size hex allen key remove the PMR Bolt Cap.
Unscrew the PMR "stem" from the PMR Manifold.
Remove the Tip Bolt O-ring this in process will allow you to slide off the PMR Beer Can. Now with have doing so take your PMR approved lubricant (I use Hater V.2) and lube the inside and out of the beer can, The bolt and the moving O-rings on the manifold. Generally all moving O-rings that make contact with something throughout the Bolt Cycle Process.
Slide the PMR Bolt (The long skinny thing
) back inside the beer can and replace the tip o-ring.
Now slide the stem back inside the manifold and screw the pmr beer can back onto the manifold.
Make sure you align the guide screw with the slit into the PMR Body.
Double check one last time to make sure that it is properly aligned.
Pat yourself on the back and anyone who says it is a pain to maintain a pmr well you know what to do (
) but be glad because you just did it hopefully in less than 3 minutes.
This entire thread took me about an hour and some of the pictures may look ****ty but the batteries in my camera were and are now dead
so I had to act fast. And I do not have anymore batteries.
But I checked the stickies and there are no pmr bolt maintenance guides so here you go. When I get some new batteries I plan on doing one about the eyes and if I have the time than maybe the reg.
I made this because I was bored and for educational purposes, so enjoy.
Any questions or concerns feel free to pm me or post a reply thanks.