[jay3303]

Ok so a couple days ago I remember someone telling me that I could make my own autococker valve tool with my cocking rod. If it can save me a good 20 bucks than I'll make one here I just need to know how to do it, thanks in advance

[jeanious]

There's no way of using your cocking rod as a valve removal tool. You can though use an allen key and grind the long side flat. Or just buy the tool from paintballgateway.com for cheap I think there selling them for like 15 bucks or less right now.

[gamble~it (Banned)]

take the hexagonal cocking rod, the plain stock one. find a socket that the cocking rod fits inside. then find a socket wrench that fits, and that should do the trick. good luck

ps: it was me who told you

[jay3303]

Haha thanks, yea I just looked back on the post and was about to edit my post with you're name, I'm gonna practice on my cocker, wish me luck haha. If I **** up I'll just take it to AA and have em put it back in real quick....actually I'm gonna take it to general joes, AA has been pissing me off lately.
Thanks again gamble
edit: you already told me goodluck lol

[gamble~it (Banned)]

lol

on pbgateway they got a valve tool fpr 9bux. but i just found my old one in my friends gearbag so yay

[GP_cheech]

a guy at my local field showed me one of those screw drivers with multiple bits that he used that he got from osh , i think. It's the part where the bits go into that was hexegonal, not round like most others. So he has a valve tool as well as a mini screw driver set.

[EvilAuthorityX]

Originally Posted by jeanious

There's no way of using your cocking rod as a valve removal tool. .

if you dont know what you are talking about then dont post

[ryanhall41]

i just made my own valve tool out of my stock cocking rod that was laying around after halblocking

just drill a 9/32 hole in the middle of it and you done it would help it you but a nut on the opposite end to help screw it in and out but i just welded a rod perpendicular to the end or it like the valve tool the sell in the t handle form

work great i will post a how to soon in the cocker and pump forum

[noclue119]

wow a lot of work for a $15 tool

[osok032168]

All I did was drill the long end of the big Allen wrench that fits the valve nut. The hole is so the valve body doesn't interfere.

[jay3303]

I just ended up giving in and bought one lol.

[harbinger626]

holy shet thread necromancy to the highest degree

[jay3303]

I know haha, I saw it on the front page and I was like wtf??? Lol

[harbinger626]

i hope they didnt rise it from the grave after a necro philic had its way with the cold dead thread lol

[noclue119]

Originally Posted by harbinger626

i hope they didnt rise it from the grave after a necro philic had its way with the cold dead thread lol

actually this guy made a really good how to thread here
http://www.pbnation.com/showthread.p...540&highlight=