Crossfire tank reg, where do the fittings go?

BlindApex · 07-28-2010, 04:05 PM

Hey all, so I'm a returning paintball player, been out the game for about 2 years. I have a 68ci/4500psi Crossfire tank (Low Pressure). When the tank was put into storage, for some reason the fill nipple, burst disks, and gauge were removed. Now I'm trying to install new ones on the regulator, but I am unsure which hole is for which piece. Is there any way I can distinguish which ports are for the burst disks (1.8k and 5k), fill nipple, and gauge?

I can get pictures of the ports if needed.

chris@CrossFire · 07-29-2010, 05:57 AM

call me at 269-383-1111 and I will walk you through it

BlindApex · 07-29-2010, 06:39 AM

^Thank you, I will give you a call once I get home later today!

bronze · 07-29-2010, 08:04 AM

Quote:

Originally Posted by chris@CrossFire

call me at 269-383-1111 and I will walk you through it

glad someone stepped up.

i was like uhhhhhhh shoot idk

BlindApex · 07-29-2010, 02:13 PM

Just got off the phone with Crossfire, they got me sorted in less than 5 minutes...that's what I call great customer service.

For anyone curious, the fill nipple and gauge ports are actually milled out to connect to each other, so you can identify those two that way, and it doesn't matter how they are oriented. The lower pressure burst disk goes in the slot with its air hole drilled closer to the ASA side, and the high pressure disk where the air hole is drilled closer to the bottle.

Thanks!