Hey guys, I have a wrath that has a Lucky board with an Ace chip. The problem is that I can only change the BPS for when it is in the eyes-on mode. But when I turn the eyes off the marker goes to a very high BPS. Can anyone tell me how to change the eyes-off BPS? Any help is appreciated.
There was a review of the Lucky Board which actually had instructions on changing the settings - since the enclosed instructions failed miserably. Check it out and see if that helps you figure it out what's going wrong.
It took a few minutes of reading to decipher but this is what I think it says. If you have dip switch 2 OFF, it will cap at 8 bps for eyes off ROF. If you have dip switch 2 ON, it will cap at the eyes off ROF of the quick start mode you're set at (see mode details on second page). So like PSP mode fires at 15bps eyes on or off based on the chart in the second page.
You should be able to move the dip switches with a very small screwdriver or pick.
As for the on/off...I am pulling only from memory so you might need to test. The housing for the 4 switches should have one side labeled ON. The side with numbers (1-4) would be the opposite side so that will be the OFF. If you have no labels left (i know it's an older board), I am pretty sure toward the solenoid will be ON.