Originally Posted by jrudcocker85
Awesome, I read that the dwell stock was at 9 but in know on the stock board the general consensus was that12.5 is the optimal setting with the lpr turned one turn in past flush according to BILL from PE. Just needed to be sure that the dwell settings on the virtue board went the same way. Thanks.
I think Bill normally says 14ms for the Ego7.
The stock setting for the stock Ego7 board is actually 16ms, but this is widely accepted as being higher than it needs to be.
You can't always assume that the setting on one manufacturer's board will be comparable to the setting on another, but the 9ms quoted by Virtue does seem very low. That's why we suggest starting with a more conservsative setting, and then dwell tuning to see if it can go lower.
Originally Posted by sharkethic86
does that go for most egos? i have a '10 and i wasn't sure what the optimal settings are.. right now i have dwell @ 12 and the lpr looks flush
If memory serves, the stock setting for the Ego10 is 10.5ms dwell, and the recommended LPR setting is two turns in from flush. Some people then turn the dwell up a couple of ms, and go in on the LPR another turn or at the most two, in order to get a smoother cycle (that is the absolute furthest I would consider going in on the Ego10 LPR - on an Ego8 or earlier, I wouldn't suggest going in more than two turns max).