[Wartortle]

Bob long closer
Supercharged engine (Got at PSP phx)
AKA 2liter reg
(many other ups but none that effect my closer's airline)

So I work at a field in Arizona, hardly ever get to play. Well today was one of those rare days that I had an opportunity to play.. Gear up, take my gun out, go to chrono. First shot is fine, around 280. Second shot and all the shots after that aren't even full cycles. So I turned my reg up a bit and blew out the hose between the LPR and the noid.

Took it to my table, opened it up, reconnected the hose and reset the LPR pressure to 80. I then backed my reg out (AKA 2liter) and walked out to the chrono to try again.

Starts shooting fine, but then wont go over 140, no matter how far in the HPR is. Then it starts to leak down the barrel and then go full auto (While leaking down the barrel) at around 140 FPS. I waited for it to stop, pulled the trigger again and same thing. After that it started shooting normal, 280 for a few shots, then back to full auto at 140.

It shot fine last night, then went straight into my gearbag.

What. The. Hell.


I DID change the battery.

[IgnoranceInABag]

pressures?

[Wartortle]

LPR is at 80, I backed my HPR out completely because the gauge on my tester is broken and pending replacement.

[IgnoranceInABag]

if you backed your hpr to 0 then your lpr shouldnt read anything

[Wartortle]

I set my LPR so that when the HPR hit it's right PSI, my LPR would be at 80.

[Wartortle]

Probably doesn't work like that, does it?

[e_friccero]

Originally Posted by Wartortle

Probably doesn't work like that, does it?

nope
zero out both regs, set the HPR to 210
then set the LPR to 80
and btw if it shoots fine the first time, don't crank up the pressure

[VANILLA COKE]

well if you have the sc your lpr should not be at 80 i have a prof(whichs runs at same as sc) and matt told me to run lpr at 55 and hpr at 180.

[B-Rabbit]

B-Rad Obama thinks you had terrible luck today.
First the S6, now the Closer.

My guns shot GREAT all day

[VividInterference86]

That makes me so mad dude, you and I got to shoot some YESTERDAY with it.

I think that curse is still upon me

I am totally convinced now.

[tokay444]

Originally Posted by VANILLA COKE

well if you have the sc your lpr should not be at 80 i have a prof(whichs runs at same as sc) and matt told me to run lpr at 55 and hpr at 180.

55 is too low. Wouldn't go below 65 unless you want severe bolt stick and fsdo. 80 on a new sc is just fine.

[VividInterference86]

Has the life of the Closer returned?

[kyotkyotkyot]

Were you standing within 10 ft of a Dye product? Shens on Dye product proximity if so.

[VividInterference86]

Hahaha!

[windar1968]

check if you have a busted oring...that same problem happen to my marq