[Zhulu]

Hi

*edit*
When I screw on my tank, air spews out of the bleed button/back cap. the button is not stuck inside and pops out what is the problem? I've replaced the 020 oring on back cap and the two orings on my plunger. thanks

[Zhulu]

i'm trying to replace the bleed o rings... how is ANYONE suppose to do this with bare hands....! i've spent at least five times as much time trying to fix this horrible gun as i've actually played with it..

[sharpshooter242]

had a similar problem, shipped it out to dye and they fixed it, but other then that i love my slg

[jferkin]

Well it happens to me sometimes.. But make sure before you push your air in take a small allen key or something nd push it all the way in.. Sometimes its not all the way in and gets stuck in the one spot.

[Zhulu]

so i replaced all bolt o rings and pushed in my bleed button as far as it can go, then when attach my air cylinder, the bleed button pops back out, but it still leaks. when i detach my tank and I push in the bleed button, it takes very little effort and becomes depressed very easily. I used to remember that it took some effort to push the button in and a gasp of air would escape.

[Zhulu]

jay i don't understand what you want me to do. please explain it again.

[Zhulu]

uhg. i didn't everything the manual said and IT STILL DOESN'T WORK. this marker is getting on my nerves.

[Xtrophy]

You tried the bleed o-rings themselves correct? The best way to get to them is to take the back cap assembly apart, if you did not do that already.

If you did not take the 050 rings off because you could not get to them let me know and I will tech you through it.

Let me know what you have tried and what you have not tried and I will do my best to help.

You can pm me on here to get ahold of me much easier than on this thread.

[Pensacolaballer]

did you lube the orings on the back cap?