[seriouslysilly]

Hi guys,
I am trying to remove the front block from my NME.
Managed to gain access to the screw within the frame inside the trigger frame.

Tried to loosen the bolt and was able to do it until it just stopped.
Is it supposed to come out all the way? Didn't want to keep turning and strip the threads.

The front block wouldn't budge either. What else am I missing?

[tjs0349]

I would take the air barb out. It might be jamming up against that. You will need a small socket wrench. Use a pair of needle noes pliars to pull the clear tubing off. It will be difficult to get off and you will probably have to pull pretty hard. Then take out the air barb with a socket wrench. Be careful not to break it. They do break somewhat easily and are a pain to get out once broken. After that you should be able to get enough force on the front block retaining bolt to get it out. Kind of odd that it's a bolt in there... Normally it's a grub screw... Previous owner must have done it.

[rzhukov]

use dremel