i got a Timmy and i don't know if it was me or the previous owner but the front grip screw has pierced the body. i have been keeping it air tight with Teflon tape but i want to fix it permanently.
i have been thinking about finding a small set screw and screw that into the hole until it is at the very top and then play a small amount of jb weld to make it airtight.. the jb weld would be placed from the inside of the body by removing the front block etc.
is there a better way to have fix this.. all help will be appreciated.
and if i missed this in a sticky im srry but i did look and i looked on intimidator owners group and googled it a few times.