[thedjmongoose]

my LCD screen on my board is partially working. Is there any way to fix the screen? a replacement etc?

[Uziel Gal]

There's a link to a "how to" guide somewhere on how to attempt re-attaching the ribbon contacts from an LCD screen - assuming of course that an issue with the LCD contacts is the problem.

Beyond that, there isn't a whole lot you can do. The screen on the E-Blade boards is not made to be replaceable, and a failed LCD normally means needing a new board.

[phantom01231]

I havent seen a E2 Board in a good bit, but if I remember right they are just soldered right to the board. Assuming it is the screen its self you could replace it if you can get the PN for it. (normaly found on the componet). But it could be a couple of diffrent things causing the problem. Your best bet is as Uziel Gal said and get a new board. Or if you can find a busted one with a good screen you could change them out.