Today I took apart the lower tube of my Superbolt pump and when I got to the valve after removing the locking nut and brass screw the valve would not budge after some vigorous tapping.
Any suggestions as to why that is or how to remove it?
Last edited by L4sT_ReSOrT : 08-13-2009 at 11:44 PM.
eventho WD-40 is a big no-no when it comes to lubing your marker it might be a time to use it. just make sure you fully clean out the body and valve with a degreaser or a good soap job before you put everything back together. you'll need to replace your valve o-ring too. no pics are needed, i dont see how they can help in this situation
Yeah... It was just reallly, really stuck in there.
I had to take the cocking rod and hammer it out.
Created a few nicks on the top of the cup seal, should still work.
The valve oring had a nick, now I know why it was leaking slightly through the bolt air receiver.