Alright, so I've been a long time without using my quest waiting to solder a new wiring harness onto the noid. I finally got around to doing it.
I had old green/black wiring on the solenoid.
I had red/red wiring which came with the Quest, and the battery harness which fit these are from Crankwalk. (both being used now)
What I did was snip half of the green/black wires off to expose wire, solder new wires on.
The noid isn't clicking.
I tried both WAS board and Rev 2.2 board.
Battery has good power.
What I am thinking is that the green/black wires aren't functional with the new red/red wires. Is this possible? If so, what can I do to fix it?
If not, what else could be my problem?
Since I last used my gear all of this worked until I put the new harness on.
Solder job seemed flawless before heat shrink went on.
Picture for reference: http://img43.imageshack.us/img43/4109/p1060094.jpg