[noctem89]

ooookay, my board kinda went haywire. In the middle of adjusting settings for my new trigger, and I noticed the light wasnt blinking. It was just staying one color. So i tried to turn it off, nothing. I thought I might have accidentally turned it into programming mode, so I tried to cycle the trigger, nothing. I put the gun down to see if the problem would resolve itself, nothing. The gun did cycle once, around 5 minutes later, then refused to respond again.
Anyone have anything as to what happened? If not, where can I get a replacement board, apart from getting a new virtue/univeral t board

[tjs0349]

Apparently you can get an Alien board for $80 off of their website. www.alienpb.com Don't know of anyone that's tried that yet though.

[noctem89]

for that price, id just rather spend the extra 20 and get the virtue board. I dunno, is the alien board compatable?

[noctem89]

aha. Its not the board its the little black boxy looking thing thats wired to the board, but just kinda hanging off. Anyone know what this is and/or where to get one

[tjs0349]

Not sure what you are refering to. Can you take a picture and post it?

[noctem89]

heh, it was the little black boxy thing. the tines were off-centered a little bit, and so I straightened them, and now it works. The thing has a red and black wire leading to it, and sits just to the left of the board in the grip frame. It isnt attatched to the board, but wires go from it to the board

but yea, problem fixed, gun roars again