Originally Posted by Woodsballerpcb
I wouldnt try to take the macroline fitting off of the asa unless you want to buy a new one... SP uses red loctite on their macroline fittings, unless you wanna heat it with a blowtorch then dont bother with it.
Take your macroline out of its fitting, make sure its smooth on the end, and push it into the fitting.
Actually, i have reused my macro fitting from my stock duckbill before.
Step 1. find an old wooden table.
Step 2. Drill holes and attach duckbill near end of table.
Step 3. Be a man.
Step 4. You should have a macro fitting in your hand now.
Originally Posted by spug
Even if it looks fine, change it anyway, they're like 10 cents.
What he said...you should always have spare tank o-rings with you. I dont remember which one it is but there is an ion o-ring that is the same as your tank o-ring, so if you have a kit you will have one.