[BioNeXuS]

Hey all,
I've searched the forums and I can't seem to find the answer to my problem.

I installed a new CP Shorty regulator and now when I air up my gun, I can pull the trigger 5-10 times before it will shoot. I've set my dwell and ROF to the stock setting. When I adjust my input pressure on the regulator, it basically airs up to 220 psi. When I try to decrease the pressure to 180 or below, it will shoot on the first trigger pull, but then the velocity on any shot after that is next to nothing and the balls fall out of the barrel. Any ideas?

I'm running a stock board with an SP firebolt, SP QEV, and a CP regulator. I am not able to put the stock regulator back on as it exploded last season.

Thanks in advance!!

[[NA]WARLORD]

Take cp apart and lube it with sleek. replace battery with new fresh one, try again.

[VcityBaller_Impy (Banned)]

or get a hyper2 or shocker maxflo, IMO CPs are trash. I hated the one that came on the LCD matrix i had.

[BioNeXuS]

Well, I took it apart and cleaned and lubed it. I noticed that my set screws for gauge ports were in a litttle too tight. Loosened those off a bit and now it seems to be working good. I'll test again later and you guys know. Thanks!