[championems]

after reading the faq's and stickies, and searching the forum, my question is still unanswered.


this was done this morning, with a bnib new style rpm. no gas, no balls. eyes off, grip off, marker on. i was listening to the solenoid click. fresh battery (9.61v).

with my jumper out of the grip, i had semi.
with my jumper in aux, i had semi.
with my jumper in aux, and safety pushed once, i had auto.
now the problem:
with my jumper in j10, i had semi.
with my jumper in j10, and safety pushed once, i had semi.
there was no ramping, regardless of number of pulls, nor speed of pulls per second.

i looked at the jumper, and it appeared normal, as did the j10 socket itself.

any light or possible solutions anyone can throw my way would be greatly appreciated.

[waarp8nt]

Start over. If you've had the marker in full auto or other modes...you'll need to turn off. Wait a little bit and turn it back on. Here are the modes;

http://www.frontiernet.net/~waarp8nt...ng%20Modes.htm

Also check out the link in my sig for more useful information.

[championems]

well, how about that.
so, wherever the jumper is when you turn it on, that is the mode it stays in?
i thank you for your answer.
also, excellent articles on the rpm, which reminds me, i have a pm to send you.

[championems]

it didn't save the edit.
nevermind the pm, is there a way to do your selectfire mod using a tapeswitch instead of a toggle?

[waarp8nt]

I guess its possible, I used the toggle because that is what I had access too. I'm not sure how the pins are located on a tapeswitch, but as you can see by the diagram/pictures all you are doing is bypassing the jumper and using the switch to complete the circuit. Good luck and LMK how it turns out.