[saiyanpride1869]

Any of you mounted a warp feed, and using the warp feed port on the board?

I tried, and all I get is constant spinning, when I checked the trigger switch, it looks like the switch is default close, and when actuated, open.

I checked the wires coming out of the warp port, and with the trigger not depressed, I get voltage, and same when I actuate the trigger, no change.

Anybody have an idea why this is happerning?


Thanks

[Paulis]

Do you have the Data Cable? I think you need it to activate the warp.

[saiyanpride1869]

Well, just had a chat with AKA, and they said that the boards on the vikings are not set up to work with warp yet.

I solved the problem by tracing the circuit down, and then solder the warp feed pulse wires directly to the points on the board that trigger the feed pulse.

If anybody wants to install a warp on their Vikings, and wants to know how to do this, PM me, and I'll tell you how to do it.