[07TippmannOwner]

The adaptor the reg screws into is facing out. How do I make it face inward. I have seen this done before i believe

[Brian Rodela]

Your ASA has what is known as a 15 degree outward angle to it. Also known as an "angled" asa. The only option is to purchase a straight one or have to do some magic and either reverse the one you have and route the wires for the noid through the hole which will be on the left side. Be sure that the reg doesn't interfere with the trigger guard and hopefully you have enough solenoid wire.

[Kanadian-Kaos]

You may have issues with it clearing the trigger frame if you do that, plus the slit for the pump arm (or solenoid wire) will be on the wrong side.

Anyways, just flip the body upside down and look inside the Vertical ASA (adaptor the reg screws into ) and you will see bolt. You need a 1/4 inch 12 point socket to remove it. Flip around the ASA and screw the bolt back in. Then figure out if it the regulator will clear the trigger frame and what you are going to do about the solenoid wire.

There are aftermarket 15degree ASA's with slots on both sides that you may want to look at. Just make sure the regulator clears the trigger frame first.

[cww516]

for the record, it clears fine with a sidewinder and an e1, and the solenoid wire can snake around to the other side and still reach.

[07TippmannOwner]

Im Making A Pump. No Wires

[07TippmannOwner]

1/4 12 point socket. thats what i am missing. specialty