Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 12-13-2008, 06:34 PM #1
no stinkin' Badges
shocktrooper's Avatar
Join Date: Apr 2006
Location: Boulder City, NV
 has been a member for 10 years
cocker from a borg body?

so i've heard that borgs are machined from merlin extrusion so that got me wondering if you could make a cocker using an mq2 and a borg body? new 06 bodies are pretty cheap on ebay now so maybe i'll give this a go.

has anyone tried this before?

shocktrooper is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 12-13-2008, 06:47 PM #2
csermonet47's Avatar
Join Date: Aug 2006
Location: Atlanta
 has been a member for 10 years
Try it. I know that the front block bolt is a lot bigger than a standard cocker, so that might be an issue. But there is even the section cut out for the pump arm. I don't see why it couldn't be done if a mq fits. You could just mid-block it so you don't need a back block machined also.
csermonet47 is offline   Reply With Quote
Old 12-13-2008, 07:33 PM #3
ghettogunner's Avatar
Join Date: Dec 2006
Location: Alaska
 has been a member for 10 years
pm eddahenry he is selling bodies and frames for way cheaper , and he works for macdev i think

ooo and the bottom tube has different air passages so .....
Ripper Pump
ghettogunner is offline   Reply With Quote
Old 12-14-2008, 08:45 AM #4
1cheeselova's Avatar
Join Date: Jun 2008
Location: Indian Harbor Beach, Fl
1cheeselova plays in the PSP
1cheeselova supports Cereal Killerz 2
1cheeselova donated to help Peyton Trent
1cheeselova is reppin' sidebar 4 life
but hopefully you can do this
*Currently in Retirement*

1cheeselova is offline   Reply With Quote
Old 12-14-2008, 11:54 AM #5
How is a PBN formed?
tweeter4's Avatar
Join Date: Mar 2007
Location: Lancaster PA
Annual Supporting Member
 has been a member for 10 years
tweeter4 plays in the PSP
 plays in the NXL
tweeter4 posts videos on PbNation
tweeter4 is one of the top 1000 posters on PbNation
All you will need to do Is get an 11/16th MQ2 Valve and fit it into the body of the borg, Then you need to cut middy slots for a bolt and sled. Then you will have to find a banjo bolt that fits the front of the body. Then you must fit a cocker board into the frame.
Dye M2, DM7, DM4, Octane Shocker FS/T
tweeter4 is offline   Reply With Quote
Old 12-14-2008, 06:19 PM #6
Join Date: Feb 2002
Location: Nanoose Bay, BC, Canada
Charger is a Supporting Member
 has been a member for 10 years
what if you were to make it a mq/airbolt cocker.. then you could use a stock macdev lpr... use the air passages that it has now.. hell.. you could even use a cyborg ram in the bottem tube as the airbolt ram.. then you could also use the stock cyborg noid too.. sounds pretty easy.. just need to drill a hole for the mq wires to go thru.. and figure out a way to fit a jam nut in there to keep the mq in place.. then find a board that it could all run off of..
My Feedback
Charger is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump